e3-hacking February 2006

e3-hacking@earth.li

23 participants
32 discussions

FB driver update + sound?!
by Mark Underwood 02 Mar '06

02 Mar '06

Just to let you all know that I am still working on the FB driver :). I have the LCD lit up in a nice all over turquoise colour but no Penguin and nothing I do seems to change that :(. The LCD registers have almost the same settings (one of the unused bits is set in my driver which wasn't set in the 2.4 kernel, but I can't see in the code where it could be set). I get 3 interrupts from the FB which looks about right as once it is up and running it's frame interrupt is disabled. The other news is that I have built all the sound stuff ok and I think it is working as the DMA interrupts go up, but all I have done so far is to 'cat /dev/urandom > /dev/dsp' which makes some difference to the noise, but as the unit is always generating noise I don't know if it is playing my noise or its normal noise! I will hopefully have time to test it with mpeg321 tonight. If it doesn't work then I guess there is a bit in the latch that I need to set to switch on the output amp. Mark ___________________________________________________________ To help you stay safe and secure online, we've developed the all new Yahoo! Security Centre. http://uk.security.yahoo.com

2 1

Just joined
by M P 27 Feb '06

27 Feb '06

I've been lurking for a few months, reading the list and waiting patiently for someone clever to get the E3 booting ! So thanks to Mark, and all the others I went to Argos earlier today and picked my £29.99 E3 to play with ! I'm reasonably good at embedded stuff, drivers etc and I look forward to get a go and help, however I lack "heavy" electronic equipment. Is there a quick "howto" to get the E3 flashed, starting feom scratch ? Do I even have to register it at all ?

1 0

Re: [E3-hacking] Keypress output
by Matt Callow 27 Feb '06

27 Feb '06

> > Can someone running the 2.6 kernel try pushing the q and j keys on their > E3 keyboard (the one on the device, not the mailboard) and let me know > if they get any output like: > > omap-keypad: Spurious key event x-y > > where x and y are numbers? I'm wondering if I've messed a cable up > putting mine back together or if it just has something odd for some of > the keys. Pressing 'q' gives me omap-keypad: Spurious key event 4-3 omap-keypad: Spurious key event 4-3 Pressing 'j' gives me omap-keypad: Spurious key event 4-5 omap-keypad: Spurious key event 4-5 the 1st event in each case occurs when the key is pressed, the 2nd occurs after a short delay Every other key I tried gave a simlar response (with different values of x and y) Matt

2 2

Keypress output
by Jonathan McDowell 26 Feb '06

26 Feb '06

Can someone running the 2.6 kernel try pushing the q and j keys on their E3 keyboard (the one on the device, not the mailboard) and let me know if they get any output like: omap-keypad: Spurious key event x-y where x and y are numbers? I'm wondering if I've messed a cable up putting mine back together or if it just has something odd for some of the keys. J. -- No... Don't stop...

1 0

RE: [E3-hacking] All your hard work...
by jasmine＠electronpusher.org 26 Feb '06

26 Feb '06

On Fri, 24 Feb 2006, George Sanders wrote: > Is it possible that Amstrad have locked down the E3 so tight to make sure it > can't be hacked and they are laughing at this??? No. There isn't a "lockdown". What's more, there are Amstrad employees being helpful and even giving us important information on how to program this thing, on this list, even. If they did make it secure, it wouldn't be possible to do anything like what we're doing. -J.

1 0

RE: [E3-hacking] All your hard work...
by en4rab 25 Feb '06

25 Feb '06

--- George Sanders <george.sanders(a)freezone.co.uk> wrote: > Is it possible that Amstrad have locked down the E3 so tight to make > sure it > can't be hacked and they are laughing at this??? Im fairly sure Amstrad do have plans to introduce a bootloader that uses RSA signatures to ensure the software it runs is properly signed so as to stop you running your own software on the E3 but so far nobody seem to have gotten an E3 from the shops with a new bootloader so it doesent appear that there is any thing to stop you, that said i havent had the chance to try my E3 which i have just bought. Even if they did change the bootloader it isnt an overly difficult job to desolder the NOR flash and reprogram it with the older bootloader then resolder it onto the board, A £15 "gascat" gas soldering iron from maplin with the hot air attachment will do for desoldering surface mount chips if you are carefull and you can put them back on with a normal soldering iron and some solder wick. And for programming the chips there are several cheap programmers available, im not sure what NOR chip the E3 uses but if its supported then the willem programmer is quite a good one (www.willem.org) there are several clones of this design available on ebay too. en4rab -- | .-. en4rab(a)yahoo.com | / \ .-. | / \ / \ .-. .-. _ _ +--/-------\-----/-----\-----/---\---/---\---/-\-/-\/\/--- | / \ / \ / '-' '-' |/ '-' '-' -END OF TRANSMISSION- __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com

1 0

NAND flash driver.
by Jonathan McDowell 25 Feb '06

25 Feb '06

I think I'm getting somewhere with the NAND flash driver; I now have the Linux mtd infrastructure detecting it and seemingly letting me read from it. I haven't tried writing yet and it's a bit of a mess, but I think the major work is done now: i2c /dev entries driver In ams_delta_init for NAND! NAND device: Manufacturer ID: 0x98, Chip ID: 0x75 (Toshiba NAND 32MiB 3,3V 8-bit) Scanning device for bad blocks Bad eraseblock 257 at 0x00404000 <snip lots of bad eraseblocks> Bad eraseblock 1841 at 0x01cc4000 Creating 3 MTD partitions on "NAND 32MiB 3,3V 8-bit": 0x00000000-0x00100000 : "Amstrad Foo" 0x00100000-0x00300000 : "E3 kernel partition" 0x00300000-0x02000000 : "E3 file system partition" usbmon: debugfs is not available ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (OMAP) ohci_hcd: block sizes: ed 64 td 64 J. -- ] http://www.earth.li/~noodles/ [] You drive a hard bargain for a [ ] PGP/GPG Key @ the.earth.li [] seagull. [ ] via keyserver, web or email. [] [ ] RSA: 4DC4E7FD / DSA: 5B430367 [] [

3 3

RE: [E3-hacking] All your hard work...
by George Sanders 24 Feb '06

24 Feb '06

Is it possible that Amstrad have locked down the E3 so tight to make sure it can't be hacked and they are laughing at this???

1 0

New buildroot config
by Martin Whitaker 24 Feb '06

24 Feb '06

Hi Folks, With help from friends I've now got a buildroot config which doesn't need busybox to be statically linked... telnetd also works properly too. Yay! The major change is telling it not to use the daily snapshots of uClibc and busybox, as well as changing to gcc4.0.2. You still need to comment out the startup scripts in inittab as before though. Attached is the new buildroot config:

1 0

RE: [E3-hacking] E3 u-boot & Linux
by Cliff Lawson 23 Feb '06

23 Feb '06

But I think most of our stuff is fairly kernel agnostic anyway. > -----Original Message----- > From: Jonathan McDowell [mailto:noodles@earth.li] > > Probably true, but the other option is to end up running an ancient > 2.4.18 based kernel. Aside from the numerous security issues that have > been fixed since then there are quite simply some things that can't be > added modularly to a kernel that we don't have proper source > for. IPv6, > for example, is something that's of use to me but impossible without a > kernel recompile. This e-mail and any attachments are confidential and intended exclusively for the addressee. If you are not the intended recipient please delete it from your system and notify the sender immediately. This message is attributed to the sender and may not necessarily reflect the views of Amstrad Plc or its subsidiaries. For further information on Amstrad Plc please visit our website: www.amstrad.com Amstrad Plc. Brentwood House 169 Kings Road Brentwood Essex CM14 4EF Registered in England : No. 955321

1 0

2024

2023

2022

2021

2020

2019

2018

2017

2016

2015

2014

2013

2012

2011

2010

2009

2008

2007

2006

2005

e3-hacking February 2006