On Mon, May 17, 2004 at 04:25:13PM +0200, Valentin Chialda wrote:
The problem is that it gives me errors when I put those commands into the boot.sh :
ifconfig -a eth0 xxx.xxx.xxx.xxx netmask 255.255.255.0 ifconfig -a eth1 xxx.xxx.xxx.xxx netmask 255.255.255.0 -- after those two lines, it gives me errors.
What are the errors?
The boot.sh is not loaded after the end of all scripts and settings ? Because the same script lines is working perfect when I write them by hand
Commands in the script should be running in the exact same situation you get when the shell appears.
The only thing I can think of (without seeing the errors) is that there might be some delay before the cards are ready to be configured. I think I put in a couple of seconds by default anyway before running boot.sh, but try adding 'sleep 10' at the start of your script.
Martin