Hello all, I have finally gotten round to building my max3232 interface for the E2's exp port, it seems to be working just fine running at 3v which i took from the 3v supply on the E2's board which i used for my Jtag leads Vref as well. But I have an issue with dumping the NAND flash, Im sure its just me being half asleep but what command should i be using to back up the entire 8MB of flash? I have compile pblq-02 but when I run: ./pblq readflash flash.bin 0x0 0x7FFFFF I get an error about the size not being divisible by 512, and if i try using a size of 0x800000 i get an error about an invalid size.
Id be extremely gratefull if someone could point out my no doubt stupid mistake and tell me what i should be doing to save the entire flash image so i can have a backup of my E2.
Thankyou en4rab
-- | .-. en4rab@yahoo.com | / \ .-. | / \ / \ .-. .-. _ _ +--/------------/----------/------/------/--/-//--- | / \ / \ / '-' '-' |/ '-' '-' -END OF TRANSMISSION-
__________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com