[sisela] two pcmcia cards details

[S. R. Voloch]

Hi,
Thanks for looking into this. Here are the details you wanted.
To recap I have a laptop with 2 PCMCIA cards but I can't make both
cards work simultaneously under Sisela.

If I boot with both cards it only detects the wireless.

Details:

Booting only with ethernet card.

login message says: eth0 detected 3com589

cardctl status says:
socket 0: 
  no card
socket 1:
  5V 16-bit PC card
  function 0: [ready]

cardctl config says:
socket 0:
  not configured
socket 1:
  Vcc 5.0V Vpp1 0.0V Vpp2 0.0V
  Interface type is "memory and I/O"
  irq 11 [exclusive] [level]
  function 0:
    config base 0x10000
      option 0x41 status 0x00
    IO 0x0300-0x030f [16 bit]

cardctl ident says:
socket 0:
  no product info available
socket 1:
  product info: "3com corporation", "3c589D", "TP,BNC LAN card version 2a" "000002"
  manfid: 0x0101,0x0589
   funcion: 6 (network)

Booting only with wireless card.

login message says: eth0 detected DLink 650W

cardctl status says:
socket 0:
   3.3V 16-bit PC card
      function 0: [ready]
socket 1:
  no card


cardctl config says:
socket 0:
    Vcc 3.3V Vpp1 0.0V Vpp2 0.0V
Interface type is "memory and I/O"
    irq 11 [exclusive] [level]
    function 0:
     config base 0x033e0
        option 0x41 
     IO 0x0100-0x013f [16 bit]
socket 1:
  not configured

cardctl ident says:
socket 0:
  product info: "DLink", "DCF-650W", ""
  manfid: 0xd601,0x0002
  funcion: 6 (network)
socket 1:
  no product info available

Booting with both cards gives the above all together for both cards
except that cardctl status on socket 1 has
function 0: [ready] [wp]

that is the [wp] is new.

Another thing I looked at was the kernel messages in Alt-F2
and it had (when booting both) 

get dev info on socket1 failed 
resource temporarily unavaliable

Thanks again 

Felipe