On Wed, May 19, 2004 at 09:29:55PM -0500, S. R. Voloch wrote:
Hi, I have an old laptop (Soyo PW980) that I want to use as a wireless bridge. It doesn't have an ethernet port but it has two PCMCIA slots. My plan was to plug a ethernet card in one of the slots and the wireless card on the other. Now, if I plug either of these cards by itself, then sisela recognizes the card and everything works. However if I plug in both cards then only one gets recognized. Is there a workaround this problem?
I'd need to see some more information to figure out what's going on. If you're able to get the system connected to the net in each case (card A, card B, cards A+B) could you send a feedback report from each using 'ytheleus feedback'?
Otherwise if you could give the output of:
cardctl status cardctl config cardctl ident
that'd be a useful start.
Martin