[E3-hacking] pbltool problem

[Edward Robbins]

Ok, got it finally.

Now installing to NAND so I guess I wont need this much now anyhow!

On Mon, Nov 26, 2012 at 2:00 PM, Edward Robbins
<edd.robbins at googlemail.com> wrote:
> Hmm... worked that once but no dice a second time... is this a common issue?
>
> On Mon, Nov 26, 2012 at 1:32 PM, Edward Robbins
> <edd.robbins at googlemail.com> wrote:
>> Ok, so I just tried it with debugging and it has booted!
>>
>> Cheers,
>> Ed
>>
>> On Mon, Nov 26, 2012 at 1:18 PM, Edward Robbins
>> <edd.robbins at googlemail.com> wrote:
>>> Hi again,
>>>
>>> I've got some free time today and have been playing with the emailer
>>> again. I've managed to build a 3.6 kernel a while ago but when I tried
>>> to upload the V2 stuff I had problems.
>>>
>>> Today I made up a new cable thinking that might be the issue, but it
>>> hasn't helped. I can get a boot log just fine, but when I run pbltool
>>> with "sudo ./pbltool -f /dev/ttyUSB0 oe-install.pbl" I get:
>>>
>>> Prodding...
>>> Handshaking...
>>> Done handshaking
>>> Compressed return block?
>>> Flushing: 0x00
>>> Flushing: 0x0E
>>> Flushing: 0x00
>>> Flushing: 0x82
>>> Flushing: 0x00
>>> Flushing: 0x52
>>> Flushing: 0x00
>>> Flushing: 0x04
>>> Flushing: 0x09
>>> Flushing: 0x1F
>>> Flushing: 0x05
>>> Flushing: 0x10
>>> Flushing: 0x40
>>> Flushing: 0xFE
>>> Flushing: 0x7B
>>> Flushing: 0x0E
>>> Flushing: 0xB0
>>> Flushing: 0x9A
>>> Compressed return block?
>>>
>>> Which then repeats forever. I've tried editing oe-install.pbl to
>>> change the baud rate (38400, 19200, 9600) but it makes no difference.
>>> I also looked for pblq but the link on
>>> http://cowlark.com/amstrad/index.html is broken.
>>>
>>> Any ideas?
>>>
>>> Thanks!